Submit Feedback

🌐 Internet Verified (Unverified by Owner): Controls have been validated using official web MIDI specifications (under CC BY-SA 4.0 via MIDI.guide), but not tested on physical hardware. Help us verify them by adjusting the sliders!
Korg

Volca Bass

Polyphonymono
Engine Typemono
Voice Count3 Voices
Timbral Parts1 Part

The Korg Volca Bass is an analog bass synthesizer featuring three analog oscillators, a peaky lowpass filter, and three independent step sequence parts.

💡 How to configure the Korg Volca Bass MIDI Editorâ–ŧ

To control your Korg Volca Bass from your web browser, connect your synth to your computer using a USB cable or a dedicated USB-to-MIDI interface.

Open the MIDI Settings panel above, set the Output Port to your connected Volca Bass device, and select the correct MIDI channel (default is channel 1). Once configured, you can map the MIDI CC layout sliders, draw automated parameter curves, and edit patches in real-time without installing any software.

Virtual MIDI Controller

Tweak controls to generate and route MIDI CC packages.

Filter

(2 controls)
LFO Cutoff Int (CC 43)0
Adjusts the depth of LFO cutoff modulation.
VCF Cutoff (CC 44)0
Adjusts the lowpass filter cutoff frequency.

LFO

(2 controls)
LFO Rate (CC 41)0
Adjusts the frequency of the LFO.
LFO Pitch Int (CC 42)0
Adjusts the depth of LFO pitch modulation.

General / Utility

(2 controls)
Slide On/Off (CC 40)0
Toggles step sequencing pitch slide.
VCF Peak (CC 45)0
Controls the lowpass filter resonance peak height.
â„šī¸ How MIDI CC Sync Works

MIDI CC is a one-way push protocol. Synthesizers cannot be queried dynamically to read their current parameter values. To synchronize these sliders, select your synthesizer's MIDI Input Port above. When you physically tweak knobs on your synth, the slider positions will instantly update on-screen to match.

No presets found for this synth.

Suggest Profile Edit

Suggest adjustments to descriptions and MIDI CC parameter mapping.

No CC parameters mapped yet. Use inputs below.