🌐 Internet Verified (Unverified by Owner): Controls have been validated using official web MIDI specifications (under CC BY-SA 4.0 via MIDI.guide), but not tested on physical hardware. Help us verify them by adjusting the sliders!

Profile ID: korg-volca-kick

Volca Kick

Polyphonymono

Engine Typemono

Voice Count1 Voice

Timbral Parts1 Part

The Korg Volca Kick is an analog kick generator and bass synthesizer based on the resonant MS-20 filter, specialized in generating punchy kick drums and sub-basses.

💡 How to configure the Korg Volca Kick MIDI Editor▼

To control your Korg Volca Kick from your web browser, connect your synth to your computer using a USB cable or a dedicated USB-to-MIDI interface.

Open the MIDI Settings panel above, set the Output Port to your connected Volca Kick device, and select the correct MIDI channel (default is channel 1). Once configured, you can map the MIDI CC layout sliders, draw automated parameter curves, and edit patches in real-time without installing any software.

Virtual MIDI Controller

Tweak controls to generate and route MIDI CC packages.

MIDI Hardware Device

Midi Ch

Test Trigger

Actions

Mixer

(1 control)

Pulse Level (CC 41)0

Adjusts the volume level of the pulse component.

Envelopes

(2 controls)

Amp Attack (CC 42)0

Adjusts the envelope generator attack time of the amplifier.

Amp Decay (CC 43)0

Adjusts the envelope generator decay time of the amplifier.

General / Utility

(7 controls)

Pulse Colour (CC 40)0

Adjusts the frequency of the pulse component's high-frequency content.

Drive (CC 44)0

Adjusts the level of distortion/overdrive saturation.

Tone (CC 45)0

Adjusts the filter tone / brightness level.

Resonator Pitch (CC 46)0

Adjusts the frequency / pitch of the MS-20 resonant circuit.

Resonator Bend (CC 47)0

Adjusts the depth of the pitch sweep envelope bend.

Resonator Time (CC 48)0

Adjusts the decay duration of the pitch sweep bend.

Accent (CC 49)0

Controls the accentuation level for active steps.

ℹ️ How MIDI CC Sync Works

MIDI CC is a one-way push protocol. Synthesizers cannot be queried dynamically to read their current parameter values. To synchronize these sliders, select your synthesizer's MIDI Input Port above. When you physically tweak knobs on your synth, the slider positions will instantly update on-screen to match.

No presets found for this synth.

Suggest Profile Edit

Suggest adjustments to descriptions and MIDI CC parameter mapping.