🌐 Internet Verified (Unverified by Owner): Controls have been validated using official web MIDI specifications (under CC BY-SA 4.0 via MIDI.guide), but not tested on physical hardware. Help us verify them by adjusting the sliders!

Profile ID: roland-sh01a

SH-01A

Polyphonypoly

Engine Typepoly

Voice Count4 Voices

Timbral Parts1 Part

The Roland SH-01A is a Boutique series reproduction of the classic SH-101 synthesizer, expanding the original monophonic design into 4-voice polyphonic, chord, and unison modes.

💡 How to configure the Roland SH-01A MIDI Editor▼

To control your Roland SH-01A from your web browser, connect your synth to your computer using a USB cable or a dedicated USB-to-MIDI interface.

Open the MIDI Settings panel above, set the Output Port to your connected SH-01A device, and select the correct MIDI channel (default is channel 1). Once configured, you can map the MIDI CC layout sliders, draw automated parameter curves, and edit patches in real-time without installing any software.

Virtual MIDI Controller

Tweak controls to generate and route MIDI CC packages.

MIDI Hardware Device

Midi Ch

Test Trigger

Actions

Mixer

(1 control)

Source Mixer Noise (CC 86)0

Controls the level of noise in the mixer.

Filter

(1 control)

VCF Cutoff (CC 74)0

Adjusts the lowpass filter cutoff frequency.

Envelopes

(4 controls)

Env Attack (CC 95)0

Adjusts the attack time of the envelope generator.

Env Decay (CC 96)0

Adjusts the decay time of the envelope generator.

Env Sustain (CC 97)0

Adjusts the sustain level of the envelope generator.

Env Release (CC 98)0

Adjusts the release time of the envelope generator.

LFO

(3 controls)

LFO Rate (CC 80)0

Adjusts the speed/frequency of the main LFO.

LFO Delay (CC 81)0

Controls the delay time before LFO modulation starts.

VCO LFO Mod (CC 82)0

Controls the depth of LFO pitch modulation applied to the VCO.

General / Utility

(3 controls)

VCF Res (CC 71)0

Adjusts the resonance level of the lowpass filter.

Pulse Width (CC 83)0

Sets the manual width or LFO modulation depth of the square wave.

Source Mixer Sub (CC 85)0

Controls the level of the sub-oscillator in the mixer.

ℹ️ How MIDI CC Sync Works

MIDI CC is a one-way push protocol. Synthesizers cannot be queried dynamically to read their current parameter values. To synchronize these sliders, select your synthesizer's MIDI Input Port above. When you physically tweak knobs on your synth, the slider positions will instantly update on-screen to match.

No presets found for this synth.

ACADEMY

Recommended lessons.

Browse all lessons →

ArpeggioIntermediate

Suggest Profile Edit

Suggest adjustments to descriptions and MIDI CC parameter mapping.